Editing Art Controller Hardware Variations
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 8: | Line 8: | ||
Any of the three terminal blocks can be left uninstalled if you would prefer to hard-wire (solder in) the connections there, or if they are otherwise not needed. | Any of the three terminal blocks can be left uninstalled if you would prefer to hard-wire (solder in) the connections there, or if they are otherwise not needed. | ||
− | |||
The output terminal block (J3) can be omitted if: | The output terminal block (J3) can be omitted if: | ||
* You want to hard-wire your load to location J3 by soldering wires into that location on the circuit board. | * You want to hard-wire your load to location J3 by soldering wires into that location on the circuit board. | ||
− | |||
The DC power input terminal block (J1) can be omitted if: | The DC power input terminal block (J1) can be omitted if: | ||
Line 18: | Line 16: | ||
* You are planning to feed 5 V power to the board through the ISP header, J4, or through the +5 V port near U1. | * You are planning to feed 5 V power to the board through the ISP header, J4, or through the +5 V port near U1. | ||
* You want to hard-wire your DC power to J1 by soldering two wires into that location on the circuit board. | * You want to hard-wire your DC power to J1 by soldering two wires into that location on the circuit board. | ||
− | |||
The trigger input terminal block (J2) can be omitted if: | The trigger input terminal block (J2) can be omitted if: |