Editing Updating EBB firmware
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 51: | Line 51: | ||
* Copy the hex file to the folder that contains the mphidflash exectuable for your OS. | * Copy the hex file to the folder that contains the mphidflash exectuable for your OS. | ||
* Connect your EBB to the PC with a USB cable. Plug in power to the EBB. | * Connect your EBB to the PC with a USB cable. Plug in power to the EBB. | ||
− | * Put your EBB in 'bootloader mode' by | + | * Put your EBB in 'bootloader mode' by pressing the PRG button and holding it down while you press and release the RST button. Then you can let go of the PRG button. |
− | |||
− | |||
− | |||
* Confirm that your EBB is in bootload mode by looking at the red and green LEDs by the USB connector. They should be blinking back and forth pretty fast. | * Confirm that your EBB is in bootload mode by looking at the red and green LEDs by the USB connector. They should be blinking back and forth pretty fast. | ||
* From the command line, type (for Linux or Mac) | * From the command line, type (for Linux or Mac) |